Basic Operation and Controls Flashcards
7 cards from real OIT practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Basic Operation and Controls flashcards as text
Which type of surface condition requires an operator to REDUCE forklift speed the most?
Answer: Wet or oily floors
Wet or oily floors drastically reduce tire traction and increase stopping distance, requiring significantly lower travel speeds.
When stacking a load at height, the operator should approach the rack and:
Answer: Stop, raise the load, then position precisely with mast controls
The forklift should be stopped before raising the load to avoid instability caused by the elevated center of gravity during movement.
What does the rated capacity nameplate on a forklift represent?
Answer: Maximum weight on level ground with the load centered at 24-inch load center
The nameplate capacity is the maximum load weight at a standard 24-inch load center on a level surface with forks at travel height.
An operator is asked to carry a load that is 500 lbs over the forklift's rated capacity. The operator should:
Answer: Refuse to carry the load and notify a supervisor
Exceeding the rated capacity is a serious OSHA violation and creates immediate tip-over risk; the operator must refuse and escalate to a supervisor.
Which of the following best describes the stability triangle on a counterbalanced forklift?
Answer: The three points formed by the two front wheels and the rear axle pivot
The stability triangle is defined by the two front drive wheels and the center of the rear steering axle, forming the forklift's stability base.
After completing a work shift, where should a forklift be parked?
Answer: In a designated parking area with forks lowered and parking brake set
Forklifts must be parked in designated areas with forks flat on the floor, parking brake engaged, and engine or power off.
What is the purpose of performing a daily pre-operational inspection on a forklift?
Answer: To identify defects before they cause an accident or equipment failure
The pre-op inspection detects mechanical defects, fluid leaks, and safety issues before the truck enters service, preventing accidents.