Medical Laboratory Technician Blood Bank and Transfusion Questions and Answers — Questions and Answers
Question 1: A patient's antibody screen is positive. The antibody identification panel shows reactivity with all panel cells, and the auto-control is also positive. All reactions are occurring at the AHG phase. Which of the following is the MOST likely cause of these results?
- A cold autoantibody
- Multiple alloantibodies
- A warm autoantibody (Correct answer)
- An antibody to a high-prevalence antigen
Correct answer: A warm autoantibody
A warm autoantibody will react with the patient's own red cells (positive auto-control) and all reagent red cells used in the panel because they all possess the common antigens the autoantibody is directed against. The reactions are typically observed at the AHG (37°C) phase. A cold autoantibody typically reacts at room temperature or colder. Multiple alloantibodies would likely show a varying pattern of reactivity, and the auto-control would be negative. An antibody to a high-prevalence antigen would cause reactivity with all panel cells, but the auto-control would be negative.
Question 2: A unit of Red Blood Cells is issued from the blood bank at 08:00 for a routine transfusion. At 08:20, the nurse calls to report that the patient's IV has failed and the transfusion has not been started. The unit has been stored in a transport cooler with appropriate coolant packs. What is the correct course of action?
- Discard the unit immediately because it has been out of the blood bank for over 15 minutes.
- Return the unit to the blood bank immediately for proper storage. (Correct answer)
- Tell the nurse to keep the unit at the bedside until a new IV is established, as long as it is within 4 hours.
- Begin the transfusion as soon as a new IV is started, regardless of the time.
Correct answer: Return the unit to the blood bank immediately for proper storage.
According to AABB Standards, a blood component that has been issued but not transfused can be returned to the blood bank for reissue only if it has not been warmed above 10°C or cooled below 1°C during storage and transport. Since the unit was not spiked and was maintained at the correct temperature in a validated cooler, it can be immediately returned to the blood bank's monitored refrigerator. The 30-minute rule applies to units kept at room temperature without a validated cooling system.
Question 3: Which of the following blood components must be stored at 20-24°C with continuous, gentle agitation?
- Fresh Frozen Plasma (FFP)
- Red Blood Cells (RBCs)
- Cryoprecipitate
- Platelets (Correct answer)
Correct answer: Platelets
Platelets must be stored at room temperature (20-24°C) with continuous gentle agitation to maintain their viability and prevent aggregation. Red Blood Cells are stored at 1-6°C. Fresh Frozen Plasma and Cryoprecipitate are stored in a frozen state, typically at or below -18°C.
Question 4: During a pretransfusion compatibility test, a medical laboratory technician finds that the patient's ABO/Rh type is A positive, and the antibody screen is negative. The crossmatch is performed with an A positive donor unit. The immediate spin crossmatch is incompatible (4+). What is the MOST likely cause of this discrepancy?
- The patient has an antibody to a low-prevalence antigen present on the donor's red cells.
- The donor unit is incorrectly labeled and is actually group B.
- The patient has a cold-reacting alloantibody not detected by the screen.
- The patient has an A2 subtype with the presence of anti-A1. (Correct answer)
Correct answer: The patient has an A2 subtype with the presence of anti-A1.
An A2 individual can produce anti-A1, which would react with A1 cells from the donor unit, causing an incompatibility at immediate spin. The antibody screen is typically performed with O cells, which would not detect anti-A1. An incorrect donor unit label (e.g., group B) would also cause incompatibility, but the A2 with anti-A1 scenario is a classic cause for this specific set of results. An antibody to a low-prevalence antigen is possible but less common, and a cold antibody should have been detected on the screen if the appropriate cells were used.
Question 5: A transfusion reaction workup is initiated on a patient who developed fever, chills, and flank pain 15 minutes into a red blood cell transfusion. The initial laboratory investigation includes a clerical check, a visual check for hemolysis in the post-transfusion specimen, and a Direct Antiglobulin Test (DAT). Which of these findings would most strongly suggest an acute hemolytic transfusion reaction?
- A clerical error discovered on the patient's wristband.
- A negative DAT on the post-transfusion specimen.
- Pink or red plasma in the centrifuged post-transfusion specimen. (Correct answer)
- The patient's temperature increased by 1°C.
Correct answer: Pink or red plasma in the centrifuged post-transfusion specimen.
Pink or red plasma (hemoglobinemia) in a post-transfusion specimen is a key indicator of intravascular hemolysis, which is the hallmark of a severe acute hemolytic transfusion reaction. A clerical error is a common cause but not a direct finding of hemolysis. A DAT can be positive, but the visual presence of free hemoglobin in the plasma is a more immediate and dramatic indicator of red cell destruction in this clinical context. An increase in temperature is a symptom but is also common in febrile, non-hemolytic reactions.
Question 6: What is the primary purpose of irradiating cellular blood components?
- To prevent bacterial contamination of the unit.
- To prevent transfusion-associated graft-versus-host disease (TA-GVHD). (Correct answer)
- To extend the shelf-life of Red Blood Cells.
- To inactivate viruses such as CMV and HIV.
Correct answer: To prevent transfusion-associated graft-versus-host disease (TA-GVHD).
Irradiation of cellular blood products (Red Blood Cells and Platelets) exposes the component to a measured dose of gamma radiation or x-rays to damage the DNA of donor T-lymphocytes. This renders them incapable of dividing and mounting an immune response against the recipient, thus preventing transfusion-associated graft-versus-host disease (TA-GVHD), a rare but often fatal complication.
Medical Laboratory Technician Blood Bank and Transfusion Questions and Answers
A patient's antibody screen is positive.
The antibody identification panel shows reactivity with all panel cells, and the auto-control is also positive.
All reactions are occurring at the AHG phase.
Which of the following is the MOST likely cause of these results?
What Practice Test Geeks adds beyond an AI chat for Medical Laboratory Technician Exam
An AI chatbot can quiz you, but it can't reproduce the exam conditions or keep your record. Here you get:
- A timed, full-length Medical Laboratory Technician Exam mock exam — 100 questions in 120 minutes with a 60% pass mark, modeled on the official exam's question count and time limit, followed by a score report broken down by exam domain.
- A fixed Medical Laboratory Technician Exam question bank: the same test every attempt, so your score is comparable from one try to the next instead of changing with every regenerated quiz.
- Progress saved on your device: completed tests, scores and missed questions stay in My Progress, so you can retake only what you got wrong.
- A printable Medical Laboratory Technician Exam cheat sheet you can print or save as a PDF.
- Medical Laboratory Technician Exam flashcards built from the same question bank.