Free Plumbing Questions And Answers — Questions and Answers
Question 1: The minimum vertical distance of an indirect drain line from the flood rim of its receptor is _______________.
- ½"
- ¾"
- 1" (Correct answer)
- 2"
Correct answer: 1"
A minimum vertical distance of 1 is required between the bottom of an indirect drain line and the flood rim of its receptor.
Question 2: Which of the following fixture types can be served by a waste and vent combo system?
- Toilets
- Sinks (Correct answer)
- Bidets
- Urinals
Correct answer: Sinks
When using CWV systems, not every fixture needs to have an individual vent. The fixtures that have been approved for a CWV installation have bigger drains installed instead of a vertical vent. The fixture obtains the necessary air for drainage in the upper section of the bigger piping because the drain diameter is greater. Toilets, bidets, and urinals cannot be put on CWV systems.
Question 3: You are attaching two lavatories that are next to each other, two urinals, and two toilets to one horizontal branch. How many fixtures can be connected to a horizontal branch at once?
Correct answer: 8
A horizontal branch drain may have up to eight fittings connected to it, according to plumbing regulations. Another name for this is a circuit vent.
Question 4: Cleanouts must be installed in order to pipe for horizontal drainage branches and building drains. The diameter of the drain and other elements define how far apart these cleanouts should be placed. The drain pipe diameter in this instance is three inches. This drain has a 40-foot running length. The pipe makes one 90-degree turn and one 45-degree turn along this journey. How many cleanouts will this installation require?
Correct answer: 2
According to the IPC, a cleanout is required for every direction change that is greater than 45 degrees and for every 40 feet of developed length when there are multiple direction changes in a run of pipe. Using these standards, we need one cleanout for a 90 degree turn and one cleanout for every 40 feet of developed length.
<br>
A cleanout is required by the UPC for every 100 feet of developed pipe length, or any fraction thereof. In addition, a cleanout is required for every aggregate direction change that is greater than 135 degrees. Using these standards, we require 1 cleanout for the distance of 40 feet, which is a fraction of 100 feet, and 1 cleanout for the aggregate direction change because it is greater than 135 degrees.
Question 5: How many P-traps can a single trap arm support in total?
Correct answer: 1
A trap arm may only have one trap at a time.
Question 6: It is necessary for flexible water connections to be _____.
- Limited to first-floor installations
- Supported
- Readily accessible
- Accessible (Correct answer)
Correct answer: Accessible
It is necessary for all flexible water connections to be reachable. This implies that they must be accessible even if they are hidden inside a cabinet or behind an access panel.
Question 7: To prevent backflow, sill cocks, hose bibs, and water heaters are typically equipped with ___.
- An air break
- A vacuum breaker (Correct answer)
- A reduced-pressure backflow preventer
- An air gap
Correct answer: A vacuum breaker
Water heaters, sill cocks, and hose bibs are typically protected against backflow hazards by vacuum breakers.
